ZETRON 2000 Series Specifications download pdf (Page 40)

System Installation

40 025-9035AA

Model 2200EX Setup

♦ Setting up a Model 2200EX

1. Remove the front door of the 2200EX and remove all cards from the chassis. Using

the lag bolts and grommets provided in the kit, mount the 2200EX chassis to the

wall. Be careful to mount the chassis close enough to the 2200 main chassis that

the interface cable provided can connect the two units. Ensure that the lag bolts hit

studs in the wall to ensure a solid mounting for the new chassis.

2. Remove the top panel of the 2200EX chassis.

3. Verify that the SLAVE Expand card is configured as follows:

JP2 = Out

JP8 = Out

JP3 through JP7 = IN

JP1 = SNG/SLV position

4. Install the SLAVE Expand card in slot 5 of the 2200EX chassis.

5. Connect the “DUAL” connector end of the 2200EX chassis interface cable to the

SLAVE Expand card’s 68-pin female connector, labeled J2. This connector is

located at the top edge of the Expand card. Tighten the thumbscrews until the cable

connector is fully seated against the card connector.

6. Route the interface cable through the cutout in the top cover and replace the top

cover on the 2200EX chassis.

7. Install the new trunk/multiport/station cards in the 2200EX chassis. (See Figure

10)

Figure 10: Possible Locations for Model 2200EX Components

123 45 67 8 9 10111213141516

TRUNK CARDS

TRUNK or TAP-TNPP SERIAL CARDS

Model 2200 Expansion Chassis

POWER SUPPLY

EXPANSION

SLAVE CARD

TRUNK or STATION CARDS

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 375 376

No comments

ZETRON 2000 Series Specifications Page 40