ZETRON 2000 Series Specifications download pdf (Page 32)

System Installation

32 025-9035AA

c. Repeat the two preceding steps but use the other test pager with the 1000 &

2000Hz tones. You should find that your channel deviation is independent of

tone frequency. Consult Zetron if your modulation is not “flat”.

4. [_] DIGITAL deviation adjustment:

RF deviation levels on binary digital transmissions are determined by your

transmitter, not by the station card.

To adjust, call a digital pager, and while the digital data is going out, use your

service monitor to adjust your transmitter for 4.5 to 5kHz deviation.

Hard Disk Card Mounting Information

The Zetron hard disk on a card for the Zetron Model 2100/2200 paging terminal is packed

separately to avoid damage to the terminal or hard disk during shipment. The hard disk

contains all of the software for the paging terminal; therefore, it must be installed before

operation of the paging terminal can take place. Installation is simple, but the hard disk

can be easily damaged. Please follow the instructions below:

1. Be sure power to the Model 2200/2100 Paging Terminal is turned off.

2. Open the packaging material containing the hard disk. It is a good idea to save the

packing materials, including the static-proof jacket, in the event you should ever

need to ship your hard disk.

3. While holding the hard disk card at the top (card-edge finger side) and bottom,

align it with the left-most card guide and the card slot. Check to make sure the

gold-plated card-edge fingers are centered over the connector. Now firmly press on

the top edge of the hard disk above the connector until it is firmly seated in the

connector.

4. Use the #4-40 screw you removed to fasten the hard disk card. Do not operate the

paging terminal until the hard disk is firmly fastened.

SCSI Disk Card Mounting Information (M2200)

The SCSI disk for the Model 2200 Pentium option is packed separately to avoid damage to

the terminal or hard disk during shipment. Please follow the instructions below to install

the SCSI disk in the Model 2200 (Refer to Figure 1 and Figure 6):

1. Be sure power to the Model 2200 Paging Terminal is turned off.

2. Attach the two supplied brackets to the SCSI disk using the supplied screws.

Caution! AVOID TOUCHING THE GOLD-PLATED CARD-EDGE FINGERS

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 375 376

No comments

ZETRON 2000 Series Specifications Page 32