ZETRON 2000 Series Specifications download pdf (Page 215)

215

RAID Hard Drive

c. From NotePad, open the “vput.bat” file. Format each line of the file as

follows:

VPUT <filename> c:\v\<filename>

d. Save and exit.

Return to the final step of Copying voice files into voice partition on RAID drive on

page 214.

IDE Disk Drive Duplicate Procedure (011-0665)

♦ Duplication procedure

1. Boot the paging terminal with one drive in the RAID controller chassis. Either

drive may serve as the source drive. Please note that if you put in two drives that

are not synchronized into the RAID controller, no copying will occur. This is

because the controller does not know which drive to use as the source drive.

2. With one drive removed the rectangular status LED corresponding to the drive will

be yellow and the RAID controller will beep once if drive #1 is removed and twice

drive #2 is removed. This is normal as the controller thinks that the removed drive

is a bad drive.

3. Install the target hard drive to into the open bay in the RAID chassis. After a few

seconds the RAID controller will recognize the new hardware and the rectangular

LED corresponding to that drive should turn green, indicating that the drive is

good.

4. The RAID controller will recognize that the new drive is not in sync with the

source and start to copy data to it. The round yellow LED to the left of the status

LEDs should start blinking to indicate that the drive is being accessed.

5. The RAID controller will duplicate a hard drive in about five minutes. When it is

done the yellow access LED will stop blinking and the rectangular status LED for

the target drive will go out indicating that the drives are synchronized.

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 375 376

No comments

ZETRON 2000 Series Specifications Page 215